Paper
2 June 1999 Semi-passive damping using continuous switching of a piezoelectric device
Claude Richard, Daniel Guyomar, David Audigier, Gil Ching
Author Affiliations +
Abstract
Passive damping using a piezoelectric device is a well-known technique. Both resistor and inductor loads connected to the piezoceramic are commonly used to attenuate a given resonance mode on a structure equipped with piezo dampers. The main drawback of this technique is its narrow band behavior and especially in the case of an inductor tuned passive piezo damper. The proposed technique is inherently wide band and does not rely on any tuned electric load. The piezoelectric device is simply continuously switched from open-circuit to short-circuit synchronously to the mechanical strain. It is called semi-passive because of the need of a sensor giving the strain of the piezo device. There is no need for external power supply unless for the low-level circuitry of the switch device. The damping efficiency appears to be twice what is obtained with pure resistive damping and is equivalent to what is achievable with a tuned inductor damper. It can work at any frequency without the need for large inductor especially for low frequency applications. A qualitative model gives an understanding of the damping mechanism.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Claude Richard, Daniel Guyomar, David Audigier, and Gil Ching "Semi-passive damping using continuous switching of a piezoelectric device", Proc. SPIE 3672, Smart Structures and Materials 1999: Passive Damping and Isolation, (2 June 1999); https://doi.org/10.1117/12.349773
Lens.org Logo
CITATIONS
Cited by 224 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Switching

Resistors

Switches

Ceramics

Polymers

Signal processing

Ferroelectric materials

RELATED CONTENT

Composite sensors and actuators
Proceedings of SPIE (February 09 1996)
Ferroelectrics in uncooled thermal imaging
Proceedings of SPIE (October 26 1998)
Smart actuators with piezoelectric materials
Proceedings of SPIE (April 26 1996)

Back to Top