6 September 1999 Cylindrical "allipse"
Author Affiliations +
Abstract
Long cylindrical mirror sections with an 'Alliptical' cross- section and an interfoci distance of approximately 1 m can be produced by means of diamond fly cutting. However, because of the finite tool radius, the generated profile is basically not an ellipse, but an equidistant ellipse or 'Allipse'. By numerical ray tracing analysis two unique conjugated 'A-points' can be found that are optically nearly equivalent with pure elliptical focal points. A reversed modeling procedure is used to predict the optimum machine configuration for producing just the required ellipse sections. Optical figure quality, focal line position and straightness are tested by a simple deflectometer set-up.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Willem D. van Amstel, R. Groenewold, T. Goos, J. van Leenders, J. Oomen, "Cylindrical "allipse"", Proc. SPIE 3739, Optical Fabrication and Testing, (6 September 1999); doi: 10.1117/12.360134; https://doi.org/10.1117/12.360134
PROCEEDINGS
7 PAGES


SHARE
Back to Top