Translator Disclaimer
19 July 1999 Final design of the active positioning actuators for the Large Binocular Telescope primary mirrors
Author Affiliations +
Proceedings Volume 3749, 18th Congress of the International Commission for Optics; (1999)
Event: ICO XVIII 18th Congress of the International Commission for Optics, 1999, San Francisco, CA, United States
The latest generation of astronomical telescopes is equipped by primary mirrors about 8 meter in diameter increasing demands not only of the general mechanical structure but also of the technical performances of the mirror support systems. The Large Binocular Telescope has two 8.4 meter primary mirrors supported on the same elevation mechanical structure and, each of them, located in a mirror cell enviroment. Into the latter structures hundredth of pneumatic actuators bear the weigth of the primary mirror and six positioning actuators find out the six degrees of freedom of the mirror itself, then a new control system is able to determine realtime the stiffness and the damping required by the primary mirror system. In this paper the authors describe the mechanical and the electronic active control system design and testing of the position actuator prototype that mechanically link the 8.4 m honeycomb mirror to six rigidly reinforced locations on each primary Mirror Cell structure. During telescope operation, the adjustable length of the actuators precisely control the six degrees of freedom of the mirror. Each actuator has a high mechanical axial stiffness and, as new feature, an active control system, based on piezoelectric elements and capacitive sensor, in order to control the axial stiffness versus damping, with a bandwidth from DC up to 50 Hz, assuring that the natural frequencies of the mirror do not degrade the optical performance of the telescope under external forces as the wind spectrum. Moreover, other requirements have been satisfied in the mechanic of the actuators: flexures are provided to minimize any moments applied to the attachment of the actuator to the mirror; one axial load cell for each actuator provides a precise realtime measurement of the external forces applied to the mirror, such as wind loads, to feedback the pneumatic force system that supports the weight of the mirror; a very sensitive and precise capacitive sensor measures the total length of the actuator to submicron resolution upon request. Last but not least each actuator has a reliable fail-safe system that limits the compressive and tensile forces that can be applied to the mirror. The mechanical and the electronic design DSP based and all the experimental tests of this actuator prototype have been performed in the Astrophysical Observatory of Arcetri laboratories under the supervision of the authors of this paper.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Luciano Miglietta, Valdemaro Biliotti, Matteo Accardo, Paolo Stefanini, Bernardo Bettini, and Claudio Braccesi "Final design of the active positioning actuators for the Large Binocular Telescope primary mirrors", Proc. SPIE 3749, 18th Congress of the International Commission for Optics, (19 July 1999);


The ESO's ELT construction progress
Proceedings of SPIE (December 13 2020)
A new graphical user interface for observatory control
Proceedings of SPIE (June 30 2006)
Adaptive secondary mirrors for the Large Binocular Telescope
Proceedings of SPIE (February 07 2003)
Adaptive secondary mirrors for the large binocular telescope
Proceedings of SPIE (December 24 2003)
Thirty Meter Telescope project update
Proceedings of SPIE (September 17 2012)

Back to Top