Translator Disclaimer
9 December 1999 Novel methods for simultaneous strain and temperature measurements with optical fiber Bragg gratings
Author Affiliations +
Abstract
We report on feasibility studies of two new approaches for simultaneous strain and temperature measurements with optical fiber Bragg gratings. In sensor applications fiber Bragg gratings cannot be thermally isolated. Therefore temperature has to be compensated or measured simultaneously with the measurand of interest. In strain sensing this is often done by measuring the wavelength response of a second Bragg grating attached to an unstrained sample specimen and comparing its response to response of the strained sample. This method is very accurate. However, often it is not possible or difficult to have unstrained samples, e.g., in rockbolt anchors with embedded fiber Bragg gratings. We propose two new simultaneous measurement concepts and compare them to known concepts. The first investigated method uses the different sensitivities to strain and temperature of the main peak of a Bragg grating in transmission compared to the back-reflected cladding modes. We will present first results of simultaneous strain and temperature measurements over a range from 2 degrees Celsius to 95 degrees Celsius up to 3500 micrometer/m in strain. This method leads to a combined resolution in temperature and strain of 4 degrees Celsius and 35 micrometer, respectively. The second method is based on two low reflectivity gratings. They are in close vicinity to each other in the fiber. Both have a small refractive index modulation of about 2 (DOT) 10-4, but one was homogeneously post-illuminated and has an increased mean refractive index. We will present first results indicating that the additional UV-illumination changes temperature- and strain-sensitivity of the post-illuminated Bragg grating slightly.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Andreas Frank, Philipp M. Nellen, and Urs J. Sennhauser "Novel methods for simultaneous strain and temperature measurements with optical fiber Bragg gratings", Proc. SPIE 3860, Fiber Optic Sensor Technology and Applications, (9 December 1999); https://doi.org/10.1117/12.372987
PROCEEDINGS
9 PAGES


SHARE
Advertisement
Advertisement
Back to Top