1 February 2000 F2 laser ablation process of silica glass
Author Affiliations +
Proceedings Volume 3885, High-Power Laser Ablation II; (2000) https://doi.org/10.1117/12.376989
Event: Advanced High-Power Lasers and Applications, 1999, Osaka, Japan
Abstract
The laser ablative figuring of the silica glass has been investigated experimentally. F2 laser and ArF excimer lasers are used as the laser light source for efficient ablation of silica glass material. The output beam of F2 and ArF laser were focused on to the surface of silica glass plate. The ablation rate were measured by a surface profilometer. The process on the surface was done by scanning in X-Y direction and a uniform ablation was observed. However the surface roughness was large as compared with the case of PMMA. The waveform of incident and transmitted laser light was measured by high speed photo-tubes to observe the time dependence of the absorption. The measured waveform indicates that the absorption was small at the leading edge of the laser pulse, and a strong ablation was induced at the latter part of laser pulse due to the excited state absorption. These phenomena are quite similar to both in F2 and ArF laser light. We have developed a simple model in which the instantaneous absorption is defined by the absorbed energy prior to the moment.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hironari Mikata, Hironari Mikata, Takahisa Jitsuno, Takahisa Jitsuno, Keiu Tokumura, Keiu Tokumura, Shinji Motokoshi, Shinji Motokoshi, Masahiro Nakatsuka, Masahiro Nakatsuka, } "F2 laser ablation process of silica glass", Proc. SPIE 3885, High-Power Laser Ablation II, (1 February 2000); doi: 10.1117/12.376989; https://doi.org/10.1117/12.376989
PROCEEDINGS
8 PAGES


SHARE
Back to Top