11 November 1999 Problems of optical fiber voltage sensor in practical usage
Author Affiliations +
Proceedings Volume 3897, Advanced Photonic Sensors and Applications; (1999) https://doi.org/10.1117/12.369319
Event: International Symposium on Photonics and Applications, 1999, Singapore, Singapore
Abstract
Optical Fiber Voltage Sensor (OVS) has potential applications in power supply network, but upon to now the OVS can not be industrially used in practice. This paper introduces some problems we met in development of practical bulk-modulation OVS using BGO crystal. The optical source must be pre-modulated so that to detected the average optical power easily. The measure error, nonlinear distortion, sensitivity produced by deviation of optical element are discussed. Analysis and test show, that a small collimating error of optical elements will lead to decrease the sensitivity and increase phase shift. So long as the angle (alpha) between the polarizer and (lambda) /4 wave plate is equal to (pi) /4, the location of the polarizer for detection and BGO is not very important and the maximum sensitivity can be achieved when the angle (gamma) between the detected polarizer and BGO is equal to (pi) /4. But if (alpha) does not equal (pi) /4 and (gamma) does not equal (pi) /4, not only the sensitivity will be decreased, but also the distortion will be increased, depending on the angle (beta) between BGO and (lambda) /4 wave plate. So we use a quartz plate to hold (lambda) /4 wave plate. So we use a quartz plate to hold (lambda) /4 wave plate in order to obtain good circular polarization light. In order to eliminate the effect of random fluctuation of average optical power, some data process must be needed. We use 80C196KC single chip CPU to calculate the instantaneous value, and the effective value of measured voltage can be displayed in this transducer. We use silicon gel insulator to introduce high voltage to sensor. Some calculation and test results are given in this paper.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Chongqing Wu, Chongqing Wu, Yongjun Wang, Yongjun Wang, Xiangjun Xin, Xiangjun Xin, } "Problems of optical fiber voltage sensor in practical usage", Proc. SPIE 3897, Advanced Photonic Sensors and Applications, (11 November 1999); doi: 10.1117/12.369319; https://doi.org/10.1117/12.369319
PROCEEDINGS
6 PAGES


SHARE
RELATED CONTENT

Gain vs phase in BOTDA setups
Proceedings of SPIE (May 29 2016)
The aging process of optical couplers by gamma irradiation
Proceedings of SPIE (August 25 2015)
VISAR error analysis and enhancement
Proceedings of SPIE (October 10 1993)
Study of ring down signal processing for fiber loop ring...
Proceedings of SPIE (November 06 2012)

Back to Top