13 October 2000 Influence of workpiece support on the generated surface in turning
Author Affiliations +
Proceedings Volume 4192, Intelligent Systems in Design and Manufacturing III; (2000) https://doi.org/10.1117/12.403682
Event: Intelligent Systems and Smart Manufacturing, 2000, Boston, MA, United States
Abstract
The tailstock is used in turning operation to guide the workpiece rotation. This paper introduces an investigation for the influences of the tailstock axial force on the turning dynamics. A set of experiments were carried out to study the effect of different axial clamping force on the vibration of the tool- workpiece system and consequently on the workpiece roundness error. Vibrations generated during turning were measured in three directions (radial, axial, and tangential). Moreover, the resulted roundness errors on the workpieces surfaces were also measured. The results showed a great dependence of both vibrations existing during turning and the resulted roundness error, on the tailstock axial clamping force. The control of this force will improve the workpiece quality and detect the other errors such as chuck clamping. There is an optimum value for this force that reduces the roundness error to a minimum value. Also the vibration signals in the axial direction correlates comparatively well with the tailstock clamping force than those in other directions.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Abdelkader A. Ibrahim, Abdelkader A. Ibrahim, A. M. A. Soliman, A. M. A. Soliman, H. A. Housin, H. A. Housin, "Influence of workpiece support on the generated surface in turning", Proc. SPIE 4192, Intelligent Systems in Design and Manufacturing III, (13 October 2000); doi: 10.1117/12.403682; https://doi.org/10.1117/12.403682
PROCEEDINGS
8 PAGES


SHARE
Back to Top