6 October 2000 Effect of abrasive size on machined workpiece surface in solid abrasive lapping
Author Affiliations +
Proceedings Volume 4231, Advanced Optical Manufacturing and Testing Technology 2000; (2000) https://doi.org/10.1117/12.402811
Event: International Topical Symposium on Advanced Optical Manufacturing and Testing Technology, 2000, Chengdu, China
Abstract
This paper studies the effect of abrasives size on machined workpiece surface in solid abrasives lapping. From the results it can be seen that the value of roughness of the machined workpiece surface increases as the size of abrasives increases. Its principle is same as ultraprecision grinding and tradition lapping. But for same size abrasives, the results got in this paper is better than them in ultraprecision grinding and tradition lapping. In this paper, the roughness of machined workpiece surface can reach Ra2.83 nm, by using the abrasives which size is 3.5μm.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jiandong Yang, Jiandong Yang, Chunlin Tian, Chunlin Tian, Yong Xiao, Yong Xiao, } "Effect of abrasive size on machined workpiece surface in solid abrasive lapping", Proc. SPIE 4231, Advanced Optical Manufacturing and Testing Technology 2000, (6 October 2000); doi: 10.1117/12.402811; https://doi.org/10.1117/12.402811
PROCEEDINGS
4 PAGES


SHARE
RELATED CONTENT

Fluid jet polishing: removal process analysis
Proceedings of SPIE (September 05 1999)
Research of optical flats in pad polishing
Proceedings of SPIE (May 20 2009)
Lapping with loose abrasives in lens manufacturing
Proceedings of SPIE (October 23 2000)
Noncontact estimate of grinding-induced subsurface damage
Proceedings of SPIE (November 10 1999)

Back to Top