16 March 2001 Enhancement of spatial resolution of microfabricated columns using localized electrochemical deposition
Author Affiliations +
This paper reports on the effect of using an analog feedback technique and electrode rotation on the Localized Electrochemical Deposition (LECD) process to enhance the spatial resolution and dimensional control during the growth of nickel micro-columns. Results shown here present the capability of the process for the fabrication of microstructures with high spatial resolution. Experiments were conducted on a specially assembled apparatus where nickel structures were electrodeposited onto Cu cathodes from a nickel sulfamate plating solution, using a non-soluble anode electrode. In the first part of our work, growth of the columns was found to be zero, partial or complete depending on the vertical traverse speed of the microelectrode away from the horizontal copper surface. In this case, dimensional control was limited. Efforts to overcome the said limitation in the second part achieved a constant growth rate with an analog closed-loop feedback control of the process. This improved technique produced columns with more even and controlled dimensions, therefore allowing for better spatial resolution of the structures. This was followed by deposition with electrode rotation, which produced columns with annulus cross-sections, indicating the existence of a uniform hollow core in the columns. This feature and dimensional control in the growth of the columns were not observed when using a stationary electrode - a novel development in the area of LECD and a possibility of fabricating micro-pipes for micro drug-delivery systems.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jian Huei Choo, Jian Huei Choo, SweeHock Yeo, SweeHock Yeo, } "Enhancement of spatial resolution of microfabricated columns using localized electrochemical deposition", Proc. SPIE 4236, Smart Electronics and MEMS II, (16 March 2001); doi: 10.1117/12.418765; https://doi.org/10.1117/12.418765


Stress analysis of a standard CMOS process
Proceedings of SPIE (September 28 1999)
New low-cost MEMS capacitive pressure sensor concept
Proceedings of SPIE (January 18 2005)
Analysis of stress-driven delamination in contact vias
Proceedings of SPIE (September 11 1996)
Selective adhesive bonding with SU-8 for zero-level-packaging
Proceedings of SPIE (February 22 2005)
Directly electroplated microstructure
Proceedings of SPIE (April 05 2001)
Monolithic multiple axis accelerometer design in standard CMOS
Proceedings of SPIE (September 14 1995)

Back to Top