Paper
16 March 2001 Laser micromachining and nickel plating of high-aspect-ratio structures in polymer molds
Author Affiliations +
Proceedings Volume 4236, Smart Electronics and MEMS II; (2001) https://doi.org/10.1117/12.418760
Event: Smart Materials and MEMS, 2000, Melbourne, Australia
Abstract
This paper presents the results of our investigations on the laser micromachining of structures in a dry film photoresist polymer (Dynachem, Laminar AX dry film) laminated on a copper clad Printed Circuit Board (PCB) and (100) Silicon wafer coated with Ti (15nm)/Cu (100 to 4000 nm) and copper seed layers. This study concentrated on investigating and comparing the effect of laser fluence (0.01 to 2 J/cm2) and number of shots (1 to 1000) on the etch characteristics of the Laminar AX dry film on both substrates. The other important aspects that were studied include the minimum required seed layer thickness for electroplating. The removal of the residual polymer layer at the end of the laser micromachining process and its effect on plating characteristics has been studied. The surface quality and roughness of the laser micromachined sites and their effect on the plated Nickel structures were studied in detail. The laser fluence and the number of shots used at this stage affected the conditions of the seed layer, which in turn influenced the plated film growth kinetics. The seed layers with thicknesses less than or equal to 0.8 mm were completely removed when high fluence (> around 1 J/cm2) was used. The seed layer surface after micromachining was characterised using Scanning Electron Microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and profilometer. High Aspect Ratio Structures (HARS) of Nickel were fabricated using the Laminar AX moulds. The highest aspect ratio achieved so far in this work is 6. The characteristics of these structures are discussed in detail.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hengyi Jin, Muralihar K. Ghantasala, Jason P. Hayes, Karlo Jolic, and Erol C. Harvey "Laser micromachining and nickel plating of high-aspect-ratio structures in polymer molds", Proc. SPIE 4236, Smart Electronics and MEMS II, (16 March 2001); https://doi.org/10.1117/12.418760
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Micromachining

Nickel

Polymers

Plating

Copper

Scanning electron microscopy

Silicon films

Back to Top