Paper
13 June 2001 Integrating experimental and analytical data for validating finite element models
Pin-Qi Xia, James M. W. Brownjohn
Author Affiliations +
Proceedings Volume 4317, Second International Conference on Experimental Mechanics; (2001) https://doi.org/10.1117/12.429597
Event: Second International Conference on Experimental Mechanics, 2000, Singapore, Singapore
Abstract
Finite element (FE) analysis is a powerful technique for structural analysis. However, the analytical result by FE method are often not consistent with the experimental results due to uncertainties or assumptions in modeling structures, which can b lead to a lack of confidence in reliability of FE models. Therefore, it is extremely important to validate an FE Model so that the structure can obtain accurate prediction for linear response under unusual loads. This paper describes a methodology for validating FE models by integrating experimental and analytical data to correct uncertainties in modeling structures, through systematic comparison with dynamic response measurements. As an example an exercise on a full-scale reinforced concrete bridge was used to investigate the technique. AN FE model was set up and uncertain parameters such as Young's modulus and mass density of concrete and boundary conditions were updated to provide an accurate structural representation.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Pin-Qi Xia and James M. W. Brownjohn "Integrating experimental and analytical data for validating finite element models", Proc. SPIE 4317, Second International Conference on Experimental Mechanics, (13 June 2001); https://doi.org/10.1117/12.429597
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Data modeling

Bridges

Finite element methods

3D modeling

Performance modeling

Civil engineering

Matrices

Back to Top