Mask defect disposition: flux-area measurement of edge, contact, and OPC defects correlates to wafer and enables effective decisions

Peter Fiekowsky; Darren Taylor; David Wang; Chien-Chu Yang; Shu-Chun Lin; L. H. Tu; K. R. Lin

doi:10.1117/12.438329

5 September 2001 Mask defect disposition: flux-area measurement of edge, contact, and OPC defects correlates to wafer and enables effective decisions

Peter Fiekowsky, Darren Taylor, David Wang, Chien-Chu Yang, Shu-Chun Lin, L. H. Tu, K. R. Lin

Author Affiliations +

Proceedings Volume 4409, Photomask and Next-Generation Lithography Mask Technology VIII; (2001) https://doi.org/10.1117/12.438329
Event: Photomask and Next Generation Lithography Mask Technology VIII, 2001, Kanagawa, Japan

Abstract

Lithographers' ability to set useful defect and contact specifications has almost disappeared as chip geometries have shrunk. As features sizes have decreased, measurement error has increased to 25% of the maximum allowable defect size. This has made defect disposition so difficult that many processes now require that all detected defects be repaired because the automatic defect sizing is almost meaningless, that is, the required guard band is nearly the size of the defect specification (Reynolds, BACUS 2000). Many mask processes have abandoned defect sizingin favor of stepper simulation, either using simulation microscope, such as AIMS, or software, such as NTI's VSS. However, AVI's optical Flux-Area measurement technique provides accuracy and repeatability that gives the simple, time tested defect specification technique new life. This study demonstrates high quality edge-, contact-, and OPC- defect disposition can be achieved using the Flux-Area technique. A test mask with a range of edge defects as well as mis-sized contacts and OPC defects was written. The mask defect sizing performed with the AVI is shown to be consistent on different chips using the same process. Thus it is shown that all the over-spec defects on the wafer were measured as over-spec on the mask. Results show that edge defect size on the wafer can be accurately predicted from the AVI defect area; that printed contact size is linearly proportional to the AVI measured area, on both square and irregular contacts; and that OPC defects (printed line-end separation errors) can be accurately predicted from AVI serif-area measurements on the mask. With the Flux-Area measurement technique as implemented on the AVI Photomask Metrology System, defects can be measured with long term repeatability and rms repeatability between machines of better than 10nm, 3% of a 0.3micrometers defect. This means that guard bands can often be reduced from 0.15micrometers to below 0.05micrometers .

Citation Download Citation

Peter Fiekowsky, Darren Taylor, David Wang, Chien-Chu Yang, Shu-Chun Lin, L. H. Tu, and K. R. Lin "Mask defect disposition: flux-area measurement of edge, contact, and OPC defects correlates to wafer and enables effective decisions", Proc. SPIE 4409, Photomask and Next-Generation Lithography Mask Technology VIII, (5 September 2001); https://doi.org/10.1117/12.438329

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available