27 February 2002 Sol-gel-deposited Sb-doped SnO2 as transparent anode for OLED: process, patterning, and hole injection characteristics
Author Affiliations +
Abstract
This paper reports on the potentialities of sol-gel deposited Sb doped SnO2(T)) as a new transparent conducting oxide (TCO) for anode in organic light emitting diodes (OLED). Multilayered films with transparency over 85% and resistivity lower than 5 103(Omega) -cm were obtained. Structural observations by Transmission Electron Microscopy (TEM) show that the films are nanocrystallized. Smaller and more uniform grains are obtained upon rapid thermal annealing. Atomic Force Microscopy (AFM) imaging shows the surface roughness does not exceed 20 A. TO films are very stable and cannot be chemically etched. Anode patterning by reactive ion etching (RIE) in a Methane- Hydrogen plasma has been experienced and is described. Typical etching around 250 A/min were obtained. TO/PEDOT/PVK/Al hole only diodes were realized to assess sol gel TO films as hole injection electrodes. Devices with threshold voltages of 6 volts were obtained. A comparison with ITO deposited by low temperature cathodic sputtering is given.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
David Vaufrey, David Vaufrey, M. Ben Khelifa, M. Ben Khelifa, Marie-Paule Besland, Marie-Paule Besland, C. Sandu, C. Sandu, Marie-Genevieve Blanchin, Marie-Genevieve Blanchin, Valentin S. Teodorescu, Valentin S. Teodorescu, Jean-Alain Roger, Jean-Alain Roger, Jacques Tardy, Jacques Tardy, } "Sol-gel-deposited Sb-doped SnO2 as transparent anode for OLED: process, patterning, and hole injection characteristics", Proc. SPIE 4464, Organic Light-Emitting Materials and Devices V, (27 February 2002); doi: 10.1117/12.457464; https://doi.org/10.1117/12.457464
PROCEEDINGS
10 PAGES


SHARE
Back to Top