29 May 2002 Remote control of integrity and safety of structures
Author Affiliations +
Proceedings Volume 4537, Third International Conference on Experimental Mechanics; (2002) https://doi.org/10.1117/12.468823
Event: Third International Conference on Experimental Mechanics, 2002, Beijing, China
Abstract
With concern to engineering structures it is of increasing importance for safety as well as for economical reasons to control, whether changes in utilization, whether aging and fatigue of materials, environmental conditions, whether time- depending response etc. might affect the material as well as the structural response as e.g. stability, safety and service-life adversely. This can be done only by measurements, based on the principles of experimental mechanics, combined with proper algorithms for data-evaluation. Application of such methods is not restricted to basic research and material testing in laboratories. They have proved to be quite useful in remote control and health monitoring of technical structures, especially of those with high risk-potentials in case of failure. They should be applied to new as well as to already existing structures in order to get reliable knowledge on the behavior of structures over the whole life-span. As yet mainly methods of electrical measuring mechanical quantities are used in a wide variety of combinations. But nowadays different optical methods are available also, which are very precise and highly reliable in the long run, relative insensible against external influences, adaptable to almost any kind of problem. An overviews on different optical methods will given.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Karl-Hans Laermann, Karl-Hans Laermann, } "Remote control of integrity and safety of structures", Proc. SPIE 4537, Third International Conference on Experimental Mechanics, (29 May 2002); doi: 10.1117/12.468823; https://doi.org/10.1117/12.468823
PROCEEDINGS
6 PAGES


SHARE
RELATED CONTENT

Fly-by-wire to fly-by-light issues and solutions
Proceedings of SPIE (October 13 1996)
An Autoreferenced Two-State Optical Fibre Reflective Sensor
Proceedings of SPIE (October 05 1986)
An Enclosed Laser Calibration Standard
Proceedings of SPIE (February 07 1985)

Back to Top