27 December 2001 Open architecture CMM motion controller
Author Affiliations +
Proceedings Volume 4563, Sensors and Controls for Intelligent Manufacturing II; (2001) https://doi.org/10.1117/12.452646
Event: Intelligent Systems and Advanced Manufacturing, 2001, Boston, MA, United States
Although initially the only Coordinate Measuring Machine (CMM) sensor available was a touch trigger probe, technological advances in sensors and computing have greatly increased the variety of available inspection sensors. Non-contact laser digitizers and analog scanning touch probes require very well tuned CMM motion control, as well as an extensible, open architecture interface. This paper describes the implementation of a retrofit CMM motion controller designed for open architecture interface to a variety of sensors. The controller is based on an Intel Pentium microcomputer and a Servo To Go motion interface electronics card. Motor amplifiers, safety, and additional interface electronics are housed in a separate enclosure. Host Signal Processing (HSP) is used for the motion control algorithm. Compared to the usual host plus DSP architecture, single CPU HSP simplifies integration with the various sensors, and implementation of software geometric error compensation. Motion control tuning is accomplished using a remote computer via 100BaseTX Ethernet. A Graphical User Interface (GUI) is used to enter geometric error compensation data, and to optimize the motion control tuning parameters. It is shown that this architecture achieves the required real time motion control response, yet is much easier to extend to additional sensors.
© (2001) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
David Chang, David Chang, Allan D. Spence, Allan D. Spence, Steve Bigg, Steve Bigg, Joe Heslip, Joe Heslip, John Peterson, John Peterson, "Open architecture CMM motion controller", Proc. SPIE 4563, Sensors and Controls for Intelligent Manufacturing II, (27 December 2001); doi: 10.1117/12.452646; https://doi.org/10.1117/12.452646


Multi-modal interaction for UAS control
Proceedings of SPIE (May 21 2015)
Reconfigurable computing for multimedia DSP applications
Proceedings of SPIE (September 18 1995)
Intelligent inspection system
Proceedings of SPIE (January 19 1997)

Back to Top