Paper
30 July 2002 Impact of synchronization errors on overlay and CD control
Author Affiliations +
Abstract
Quality of exposures on Step&Scan systems highly depends on stages synchronization. While scanning, wafer and reticle stages must have same relative speed (4x ratio) and directions. In this paper, we investigate the tolerance to lateral vibrations of 0.18micrometers and 0.12micrometers gate patterning respectively on an ASML PAS5500/750E scanner (KrF) and a PAS5500/900 scanner (ArF) exposure tools. Results should be given both on the MA impact on overlay and the MSD effect on CD control. But, as no adapted experimental method has been found to correlate overlay degradation to induced MA and then confirm the theory that 1nm of MA induces 1nm of translation, only results on CD control will be discussed, including lateral MSD impact on nominal CD variations, process latitudes degradations and intrafield CD dispersion. In particular, we will show that MSD effect on CD strongly differs from 248nm imaging process to 193nm one.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Emmanuelle Luce, Sebastien Mougel, Pierre-Jerome Goirand, and Jerome Depre "Impact of synchronization errors on overlay and CD control", Proc. SPIE 4691, Optical Microlithography XV, (30 July 2002); https://doi.org/10.1117/12.474634
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Critical dimension metrology

Modeling

Optical lithography

Electroluminescence

Scanners

Semiconducting wafers

Optical proximity correction

RELATED CONTENT

RuMBa a rule model OPC for low MEEF 130...
Proceedings of SPIE (September 05 2001)
Impact of mask errors on full chip error budgets
Proceedings of SPIE (July 26 1999)
Hidden CD errors due to reticle imperfection
Proceedings of SPIE (September 14 2001)

Back to Top