1 August 2002 EUVL mask fabrication for the 45-nm node
Author Affiliations +
Proceedings Volume 4754, Photomask and Next-Generation Lithography Mask Technology IX; (2002) https://doi.org/10.1117/12.476989
Event: Photomask and Next Generation Lithography Mask Technology IX, 2002, Yokohama, Japan
Abstract
The extreme ultraviolet lithography (EUVL) mask differs from its predecessors in many ways. The most significant change is that the EUVL mask is reflective, introducing many new film layers and mask sensitivities. An additional complication is the small linewidths associated with the 45-nm node that is targeted for EUVL mask introduction. This paper concentrates on the physical specifications associated with the 45-nm node EUVL mask. Relative to current masks, the defect levels must be lower and the film quality must be higher. Standard cleans may be incompatible with new mask requirements. To understand the development requirements, the cleaning efficiency, film removal, film roughness, defect levels and film reflectivity are quantified on both EUVL mask film monitors and EUVL masks. Target specifications and measured properties of the 45-nm node masks will be compared.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Emily Fisch, Louis Kindt, Michael J. Lercel, Kenneth C. Racette, Carey T. Williams, "EUVL mask fabrication for the 45-nm node", Proc. SPIE 4754, Photomask and Next-Generation Lithography Mask Technology IX, (1 August 2002); doi: 10.1117/12.476989; https://doi.org/10.1117/12.476989
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT

Cr absorber mask for extreme-ultraviolet lithography
Proceedings of SPIE (January 22 2001)
Development status of EUVL mask blank and substrate
Proceedings of SPIE (October 13 2011)
EUV mask absorber characterization and selection
Proceedings of SPIE (July 19 2000)
EUV mask fabrication with Cr absorber
Proceedings of SPIE (July 21 2000)
Inspection and repair of EUV
Proceedings of SPIE (March 11 2002)

Back to Top