18 October 2002 Tapping force measurement by using micromachined cantilevers and laser systems
Author Affiliations +
Proceedings Volume 4902, Optomechatronic Systems III; (2002) https://doi.org/10.1117/12.467331
Event: Optomechatronic Systems III, 2002, Stuttgart, Germany
Abstract
Measurement of periodical contact force of the tapping stylus is very important for performance evaluation of soft material profilometry. So far, simulations are perfomred to estimate the force, and force calibration cantilevers are used to measure small contact force of AFMs. Since the tappign stylus uses larger tappign force compared to AFMs, micro cantilevers made of glass are developed for the force measuremetn of range from mN to μN.The levers are calibrated by using a standard cantilever made of silicon,which is fabricated by a micromachining process. A laser interferometre system is used for the calibration of glass cantilever spring constant. A laser Doppler vibrometer is used to measure the velocity of the cantilevers, and the force is estimated from the velocity signal by an integration.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Takeshi Hatsuzawa, Takeshi Hatsuzawa, Masanori Hayase, Masanori Hayase, Toshiaki Oguchi, Toshiaki Oguchi, } "Tapping force measurement by using micromachined cantilevers and laser systems", Proc. SPIE 4902, Optomechatronic Systems III, (18 October 2002); doi: 10.1117/12.467331; https://doi.org/10.1117/12.467331
PROCEEDINGS
8 PAGES


SHARE
Back to Top