1 July 2003 Fiber lasers: materials, structures and technologies
Author Affiliations +
Abstract
Rare earth doped silica based fiber lasers and amplifiers have been shown to be suitable for a variety of applications in industry, science and medicine. They can yield very high power output both in the pulsed and cw regime with high efficiency, reliability and beam quality. Great progress was possible by new design concepts as non-symmetric double clads and large mode area guiding structures and by carefully tailoring the material properties. Extreme power load and complicated fiber structures make high demands on the preparation technology. Special aspects of material and technology development will be discussed in the following. Basic requirement for a successful production of defined fiber core compositions is the knowledge of the incorporation mechanism of the rare earths into the high silica matrix. Diffusion processes during the preparation steps determine refractive index distribution, geometry and numerical aperture. Strong concentration dependences of codopants and the interaction between codopants and active components must be taken into account. The optical properties of rare earths ions can be tailored by defined codopant relations according to the intended application. Some unusual basic loss contributions of certain rare earths have to be considered and controlled in order to get high laser performance. Loss effects by UV radiation play a role if UV cured coatings are used or if the fibers are provided with Bragg gratings as laser mirrors.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Johannes Kirchhof, Johannes Kirchhof, Sonja Unger, Sonja Unger, Anka Schwuchow, Anka Schwuchow, } "Fiber lasers: materials, structures and technologies", Proc. SPIE 4957, Optical Fibers and Sensors for Medical Applications III, (1 July 2003); doi: 10.1117/12.498062; https://doi.org/10.1117/12.498062
PROCEEDINGS
15 PAGES


SHARE
Back to Top