2 June 2003 Three-dimensional measurement by tilting and moving objective lens in CD-SEM
Author Affiliations +
Abstract
There is an increasing necessity for 3D measurement of formed patterns in the semiconductor manufacturing process, and the development of the 3D measurement technology is required even in CD-SEM. In order to obtain 3D images, it is necessary to acquire at least two tilted images from different directions. However, the procedure of tilting the specimen stage is disadvantageous from the throughput point of view. Therefore, we devised the T-MOL system, which enables the acquisition of tilt images without the deterioration of the resolution by tilting the primary electron beam. Moreover, the algorithm of the parallel projection for the 3D reconstruction was developed. Tests proved that new T-MOL electron optical system provides 4nm resolution tilting angle at 5 degrees and that 3D analysis based on T-MOL images is effective.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kouji Kimura, Kouji Kimura, Kazuo Abe, Kazuo Abe, Yasuko Tsuruga, Yasuko Tsuruga, Hitoshi Suzuki, Hitoshi Suzuki, Nobuo Kochi, Nobuo Kochi, Hirotami Koike, Hirotami Koike, Yuuichiro Yamazaki, Yuuichiro Yamazaki, } "Three-dimensional measurement by tilting and moving objective lens in CD-SEM", Proc. SPIE 5038, Metrology, Inspection, and Process Control for Microlithography XVII, (2 June 2003); doi: 10.1117/12.483687; https://doi.org/10.1117/12.483687
PROCEEDINGS
6 PAGES


SHARE
Back to Top