18 November 2003 Analysis of laser drilling process for substrate by optical simulation rectified at the ablation rate
Author Affiliations +
Proceedings Volume 5063, Fourth International Symposium on Laser Precision Microfabrication; (2003) https://doi.org/10.1117/12.541163
Event: Fourth International Symposium on Laser Precision Microfabrication, 2003, Munich, Germany
Abstract
The shape of a processed hole is a key factor for laser drilling system. There are many studies to calculate the behavior of heat or the reaction of molecules in a substrate after laser irradiation. These simulations enable calculation of removed volume by laser power. However, there were some difficulties to estimate the shape of processed hole. To solve the problem, the shape of processed hole was calculated by optical simulation and the ablation rate. The laser intensity distribution on the substrate was calculated by optical simulation considered with diffraction of beam and the aberrations of optics. Furthermore the results of optical simulation were rectified by ablation rate. The calculated shape of the processed hole showed good agreement with actual. This simulation can be used to control the laser drilling process to realize high quality holes.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Katsuichi Ukita, Katsuichi Ukita, Yasuhiro Mizutnai, Yasuhiro Mizutnai, Daisuke Yokohagi, Daisuke Yokohagi, Koki Ichihashi, Koki Ichihashi, Hidehiko Karasaki, Hidehiko Karasaki, } "Analysis of laser drilling process for substrate by optical simulation rectified at the ablation rate", Proc. SPIE 5063, Fourth International Symposium on Laser Precision Microfabrication, (18 November 2003); doi: 10.1117/12.541163; https://doi.org/10.1117/12.541163
PROCEEDINGS
4 PAGES


SHARE
Back to Top