10 October 2003 High-gain 0.8-μm CMOS readout integrated circuit for FM/CW line-imaging ladar
Author Affiliations +
Abstract
We are engaged in research of readout techniques and development of readout integrated circuits for active and active/passive imaging systems under development at the Army Research Laboratory. Here we report a readout integrated circuit chip designed for ARL's FM/cw line-imaging ladar. The readout chip consists of two 1 x 8 element arrays of high-gain amplifiers that convert the input photocurrent signal to a voltage signal appropriate for digitization. Each amplifier consists of a transimpedance input stage op amp followed by a voltage-gain op amp and output buffer. The input transimpedance stage is a CMOS operational amplifier designed for a transimpedance gain of almost 1 MΩ. The voltage amplifier of stage two, also an operational amplifier, is designed to provide additional gain of about 150. Test chips have been fabricated and are being tested. The initial measured transimpedance gain of the entire amplifier cell is 130 MΩ. We discuss the chip design, physical layout, and initial performance test results.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
William B. Lawler, William B. Lawler, Jorge Garcia, Jorge Garcia, Fouad E. Kiamilev, Fouad E. Kiamilev, } "High-gain 0.8-μm CMOS readout integrated circuit for FM/CW line-imaging ladar", Proc. SPIE 5074, Infrared Technology and Applications XXIX, (10 October 2003); doi: 10.1117/12.488177; https://doi.org/10.1117/12.488177
PROCEEDINGS
10 PAGES


SHARE
RELATED CONTENT

ROIC for gated 3D imaging LADAR receiver
Proceedings of SPIE (September 11 2013)
A low power CMOS trans impedance amplifier for FM cw...
Proceedings of SPIE (September 19 2013)
Design of 128×128 two-color IRFPA readout circuit
Proceedings of SPIE (October 15 2015)
Novel 1.25 Gb s CMOS burst mode optical receiver with...
Proceedings of SPIE (April 21 2003)

Back to Top