27 October 2003 Dealing with friction in a reusable six-degrees-of-freedom adjustment mechanism with sliding contacts
Author Affiliations +
Although the possibility of a 6 degrees of freedom adjustment based on a single body pulled onto on six adjustable supports follows directly from the kinematic theory, such mechanisms are seldom used in actual products. Two major drawbacks for the use of this solution are: 1. Due to the sliding contact between the body and the supports, friction will occur and may inhibit movement. 2. Coupling between the adjusted axes cannot be avoided, this may interfere with the necessity of an adjustment procedure with a limited number of iterations This paper presents a matrix calculation method that offers a prediction whether the body will move as required, depending on the position of the supports and on the magnitude of the friction. This method enables to check the functionality of a design. This method has been used in the design of several adjustment mechanisms consisting of a body pulled onto six supports. The matrix calculation method also allows predicting the movement of the adjusted body due to adjustment of the separate supports. Using this it is relatively simple to simulate the movements that an operator will observe, and in this way check whether an operator is capable to handle the couplings present in the adjustment. Using the simulation the adjustment procedure can be optimized.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Friso Klinkhamer, Friso Klinkhamer, "Dealing with friction in a reusable six-degrees-of-freedom adjustment mechanism with sliding contacts", Proc. SPIE 5176, Optomechanics 2003, (27 October 2003); doi: 10.1117/12.509122; https://doi.org/10.1117/12.509122


SCOUT seam follower
Proceedings of SPIE (January 31 1994)
Measurement and control for mechanical compressive stress
Proceedings of SPIE (December 26 2001)
Fourier Transform Method For Optical Linewidth Measurement
Proceedings of SPIE (October 14 1984)
Measuring layer-specific depth-of-focus requirements
Proceedings of SPIE (March 06 2008)

Back to Top