24 February 2004 Comparison of columnar water vapour measurements using the CO2 DIAL method and GPS data analysis
Author Affiliations +
Abstract
Two remote sensing techniques used to measure water vapor content in the atmosphere are presented: the Lidar/Dial technique and the GPS data analysis method. The dial method, as is well known, can be used to obtain range resolved measurements or an average concentration measurement on the long path using a target topographic method. This methodology permits measurement of the concentration of atmospheric trace gases and, in particular, water vapour profiles. The second remote sensing method is based on an application of the GPS (Global Positioning System). It enables the assessment of the signal propagation delay from satellites to ground-based receivers. Once ground temperature and atmospheric pressure are measured and the GPS signal delay is known, then an estimate of the columnar water vapour content can be performed. In this paper a comparison between the two remote sensing techniques of water vapour measurement are present.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Carlo Bellecci, Carlo Bellecci, Gaetano D'Aquila, Gaetano D'Aquila, S. Gabriele, S. Gabriele, Pasquale Gaudio, Pasquale Gaudio, Sergio Martellucci, Sergio Martellucci, Graziella Ribecco, Graziella Ribecco, Maria Richetta, Maria Richetta, "Comparison of columnar water vapour measurements using the CO2 DIAL method and GPS data analysis", Proc. SPIE 5232, Remote Sensing for Agriculture, Ecosystems, and Hydrology V, (24 February 2004); doi: 10.1117/12.510653; https://doi.org/10.1117/12.510653
PROCEEDINGS
7 PAGES


SHARE
Back to Top