28 May 2004 Study of OPC for AAPSM reticles using various mask fabrication techniques
Author Affiliations +
AAPSM masks require OPC correction through pitch in order to print a linear dark line response vs the design CDs. The masks also require correction for the clear intensity imbalance caused by the phased etched Qz wall edge. The clear intensity can be balanced by two approaches;(or a combination of the two) data biasing or wet undercut etching of the Qz etched opening. IC manufacturers would like to use one OPC model that will work for any mask fabrication approach. This paper shows that there is no OPC difference observed in either the aerial image or the printed image of several OPC learning patterns. The study includes CD through pitch for dense (1:1) L/S Patterns and Isolated Line CD vs line-space ratio. The images were analyzed for the dark line linearity, the clear CD balance though pitch, and the clear CD balance with focus (phase error effects -PES).
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Gregory P. Hughes, Gregory P. Hughes, Denny Kamaruddin, Denny Kamaruddin, Kent H. Nakagawa, Kent H. Nakagawa, Susan MacDonald, Susan MacDonald, Bill Wilkinson, Bill Wilkinson, Craig West, Craig West, Keuntaek Park, Keuntaek Park, } "Study of OPC for AAPSM reticles using various mask fabrication techniques", Proc. SPIE 5377, Optical Microlithography XVII, (28 May 2004); doi: 10.1117/12.536138; https://doi.org/10.1117/12.536138


Film stress changes during anodic bonding of NGL masks
Proceedings of SPIE (July 20 2000)
New approach to optical proximity correction
Proceedings of SPIE (December 17 1998)
Reticle process effects on OPC models
Proceedings of SPIE (July 29 2002)
Mask topography effect in chromeless phase lithography
Proceedings of SPIE (December 05 2004)

Back to Top