Paper
29 July 2004 Active vibration damping using a self-sensing electrodynamic actuator
Author Affiliations +
Abstract
Shunt damping for piezoelectric actuators has been extensively studied using passive, tuned or negative capacitance components. Recently it has been noted that a capacitor together with a negative resistance amplifier can also be used for shunt damping using electrodynamic actuators with a low cut-off frequency. However simulations presented in this study indicate that this method is not appropriate for electrodynamic actuators with a high electrical cut-off frequency. This study compares experimental and simulation results of three control approaches obtained with a simple electrodynamic shaker that has a high electrical cut-off frequency: first, proportional current feedback; second, induced voltage feedback estimated with a Wheatstone bridge and third, induced voltage feedback estimated with an Owens bridge which compensates for the inductance of the shaker. The study shows that induced voltage feedback using an Owens bridge results in a negative inductance component that is an appropriate means to obtain vibration damping of a single degree of freedom system. Imperfect tuning to the magnetic parameters and interaction with power amplifier dynamics limit the bandwidth.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Christoph K.P. Paulitsch, Paolo Gardonio, and Stephen J. Elliott "Active vibration damping using a self-sensing electrodynamic actuator", Proc. SPIE 5386, Smart Structures and Materials 2004: Damping and Isolation, (29 July 2004); https://doi.org/10.1117/12.539737
Lens.org Logo
CITATIONS
Cited by 7 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Actuators

Electrodynamics

Inductance

Resistance

Amplifiers

Bridges

Wheatstone bridges

Back to Top