Design and analysis of ultrasonic horn for USDC (ultrasonic/sonic driller/corer)

Zensheu Chang; Stewart Sherrit; Xiaoqi Bao; Yoseph Bar-Cohen

doi:10.1117/12.540000

29 July 2004 Design and analysis of ultrasonic horn for USDC (ultrasonic/sonic driller/corer)

Zensheu Chang, Stewart Sherrit, Xiaoqi Bao, Yoseph Bar-Cohen

Author Affiliations +

Proceedings Volume 5388, Smart Structures and Materials 2004: Industrial and Commercial Applications of Smart Structures Technologies; (2004) https://doi.org/10.1117/12.540000
Event: Smart Structures and Materials, 2004, San Diego, CA, United States

Abstract

In-situ sampling and analysis is one of the major objectives of future NASA exploration missions. Existing drilling techniques are limited by the need for large axial forces, holding torques, and high power consumption. Lightweight robots and rovers have difficulties accommodating these requirements. These requirements are becoming increasingly tougher to meet as the need for drilling techniques is expanding to reach deeper into the subsurface. To address these key challenges to the NASA objective of planetary in-situ rock sampling and analysis, a drilling technology called ultrasonic/sonic driller/corer (USDC) was developed. The USDC uses a novel driving mechanism, transferring ultrasonic vibration to sonic frequency impacts with the aid of a free-flying mass block (free-mass). The free mass then drives the drill bit. The actuator consists of a stack of piezoelectric disks with a horn that amplifies the induced vibration amplitudes. To meet the need for deep driller the USDC was modified to form the Ultrasonic/Sonic Gopher. Drilling to the depth of several meters in ice or hard rocks requires the optimization of the amplification of the vibration displacement and velocity that are generated by the piezoelectric materials. For this purpose, various horn designs were examined analytically. Conventional and new designs of the horn were analyzed using finite element modeling and the results allow for the determination of the control parameters that can enhance the tip displacement and velocity. The results of the modeling are described and discussed in this paper.

Citation Download Citation

Zensheu Chang, Stewart Sherrit, Xiaoqi Bao, and Yoseph Bar-Cohen "Design and analysis of ultrasonic horn for USDC (ultrasonic/sonic driller/corer)", Proc. SPIE 5388, Smart Structures and Materials 2004: Industrial and Commercial Applications of Smart Structures Technologies, (29 July 2004); https://doi.org/10.1117/12.540000

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE