29 September 2004 Design and initial test results of a CCD fan-out board with integrated preamplifier and ESD protection for the scientific instrument ELMER at the GTC 10-m telescope
Author Affiliations +
Abstract
The scientific instrument ELMER for the GTC 10-m telescope integrates an E2V Technologies CCD44-82 detector and can optionally use the MIT/LL CCID-20 device. Fan-out electronics have been developed that support both detectors reusing the same PCB design and cabling. The main system component, the fan-out board, provides dual-channel input clamp and preamplification of the CCD output signal as well as filtering and active ESD protection of all the CCD lines within a 60x80mm envelope. The preamplifier stage is based on complementary bipolar operational amplifiers with dielectric isolation technology for optimum noise performance and minimum settling time. Matched, discrete JFET buffers are used for improved DC precision. Preliminary tests performed on the system yield 2.0μVrms preamplifier noise after CDS at 50kHz readout frequency. Slew rate in excess of 230V/μs and settling time well below 75ns have been obtained for a gain 4 preamplifier configuration driving non terminated coaxial cable.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Marcos Suarez Valles, Marcos Suarez Valles, Ralf Kohley, Ralf Kohley, Rafael Vilela, Rafael Vilela, Agustin Casanova, Agustin Casanova, } "Design and initial test results of a CCD fan-out board with integrated preamplifier and ESD protection for the scientific instrument ELMER at the GTC 10-m telescope", Proc. SPIE 5499, Optical and Infrared Detectors for Astronomy, (29 September 2004); doi: 10.1117/12.550442; https://doi.org/10.1117/12.550442
PROCEEDINGS
12 PAGES


SHARE
RELATED CONTENT


Back to Top