8 October 2004 F2 laser ablation of silicone rubber
Author Affiliations +
Proceedings Volume 5662, Fifth International Symposium on Laser Precision Microfabrication; (2004) https://doi.org/10.1117/12.596303
Event: Fifth International Symposium on Laser Precision Microfabrication, 2004, Nara, Japan
The ablation of silicone rubber (polydimethysiloxane, [SiO(CH3)2]n) by 157-nm F2 laser irradiation has been studied. The ablation threshold fluence (Fth) was approximately 140 mJ/cm2. The irradiated surface swelled and was modified to SiO2 for laser fluences below Fth. No carbon contamination was observed in the SiO2. Above Fth, the surface of etched silicone rubber was structurally well defined and precisely patterned. The chemical composition of the etched surface demonstrated little change. When the silicone rubber was irradiated at laser fluences of nearly Fth, conical structures were formed on the surface. It is supposed that residual carbon photodissociated by laser irradiation initiated cone formation by locally shifting Fth to a higher value. In situ mass spectrometric analysis of gaseous products evolved during F2 laser irradiation of silicone rubber showed that CH3 and CH4 components dominated for laser fluences below Fth, and CO component dominated for laser fluences above Fth. The high photon energy (7.9 eV) of an F2 laser could photodissociate preferentially weak bonds (Si-C) of silicone for lower laser fluence and almost all bonds (Si-C, C-H, Si-O) of silicone for higher laser fluence.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hiromitsu Takao, Hiromitsu Takao, Masayuki Okoshi, Masayuki Okoshi, Narumi Inoue, Narumi Inoue, } "F2 laser ablation of silicone rubber", Proc. SPIE 5662, Fifth International Symposium on Laser Precision Microfabrication, (8 October 2004); doi: 10.1117/12.596303; https://doi.org/10.1117/12.596303

Back to Top