12 May 2004 Advanced layout fragmentation and simulation schemes for model-based OPCC
Author Affiliations +
Abstract
Traditional model based OPC software operates under a set of simple guiding principles. First, a design is fragmented into finitely sized segments, the sizes and numbers of which are limited by run-time and mask constraints. Within each fragment the intensity profile (aerial image) and edge-placement error (EPE) are calculated at a single location. Finally, the length of the entire fragment is moved to correct for the EPE at that location. This scheme has potential limitations in certain cases. For instance, cases where the aerial image contour (and therefore EPE) vary at a higher frequency than the minimum allowed fragmentation frequency. This so-called aerial image ripple problem can challenge the abilities of simple model based OPC. In addition, certain advanced RET schemes require that EPE be controlled in areas that have no adjacent mask polygon. Similarly, certain double-exposure RETs require the mutual optimization of features on multiple mask layers. Our paper will describe a flexible model based OPC scheme called Matrix OPC, which has proven capabilities of resolving these and many other advanced RET problems.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
James Word, Andres Torres, Pat LaCour, "Advanced layout fragmentation and simulation schemes for model-based OPCC", Proc. SPIE 5754, Optical Microlithography XVIII, (12 May 2004); doi: 10.1117/12.598848; https://doi.org/10.1117/12.598848
PROCEEDINGS
10 PAGES


SHARE
RELATED CONTENT

Enhanced model-based OPC for 65 nm and below
Proceedings of SPIE (December 06 2004)
Image fidelity verification: contourIFV
Proceedings of SPIE (May 03 2004)
0.31k1 ArF lithography for 70-nm DRAM
Proceedings of SPIE (May 04 2005)

Back to Top