Translator Disclaimer
8 June 2005 Percussion drilling of polyimide using VUV and UV solid state lasers
Author Affiliations +
Abstract
Percussion drilling of blind holes and vias in Kapton film was investigated using Q-switched solid state lasers operating at UV (355nm) and VUV (266nm) wavelengths. Holes were analyzed using different methods such as scanning electron microscopy (SEM) and surface profilometry. Ablation rates for the two wavelengths are compared. No abrupt thresholds were found and there was no evidence of an incubation effect within the first few pulses. Introducing pauses during the drilling increased the number of shots required for perforation of the film. The effects of fluence on diameter, depth and taper of the holes are presented. Smaller and neater holes are achieved more accurately with a lower fluence. An observed skin effect brought about by long exposure to low fluence VUV laser light is also discussed.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C. Mullan, D. Ilie, Sebastian Favre, Gerard M. O'Connor, and Thomas J. Glynn "Percussion drilling of polyimide using VUV and UV solid state lasers", Proc. SPIE 5827, Opto-Ireland 2005: Photonic Engineering, (8 June 2005); https://doi.org/10.1117/12.605151
PROCEEDINGS
11 PAGES


SHARE
Advertisement
Advertisement
Back to Top