Paper
23 May 2005 Mechanical reliability of optical fibre for strain sensors
Author Affiliations +
Proceedings Volume 5855, 17th International Conference on Optical Fibre Sensors; (2005) https://doi.org/10.1117/12.623655
Event: 17th International Conference on Optical Fibre Sensors, 2005, Bruges, Belgium
Abstract
The reliability of optical fibre for sensor applications is an important issue since they are embedded in structures. The production of these sensors sometimes requires that the coating is stripped from the optical fibres with hot sulphuric acid. Tests conducted on the static fatigue of optical fibres under water, where the time to failure is measured at different stresses showed a deviation from the power-law equation. This indicates an increase in the stress corrosion parameter, n, at lower stress. Tests done using a two-point bend machine to measure the fracture strength of fibre at different time intervals after previous loading to a fixed stress showed a slight increase with time before the strength starts decreasing. This can be explained by the suggestion that the silica bonds deform by twisting to decrease the stretch in the bonds themselves before cracking. However, this might be a problem for optical fibres strain sensors used at high stress.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yehia M. El Shazly and Stephen N. Kukureka "Mechanical reliability of optical fibre for strain sensors", Proc. SPIE 5855, 17th International Conference on Optical Fibre Sensors, (23 May 2005); https://doi.org/10.1117/12.623655
Lens.org Logo
CITATIONS
Cited by 5 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical fibers

Sensors

Corrosion

Reliability

Silica

Failure analysis

Glasses

Back to Top