1 September 1975 Measurement Of Flight Simulator Visual System Performance
Author Affiliations +
Measurement of resolution, modulation, and contrast on visual displays for flight simulators must be made in order to objectively assess visual system performance. A method of analyzing the image quality of a total visual system is to place a television camera at the pilot's eyepoint and set up to look at a small portion of the visual display. The camera's video output can then be analyzed to determine the level of performance. Resolution and modulation data is obtained on the entire visual system including the display device and image generation system. The observer camera must have several special qualities in order to yield accurate results. High sensitivity is needed because most visual displays have low brightness. A linear response with brightness is also required. By modifying an average-quality vidicon camera with a silicon target vidicon and a unique beam blanking circuit, a low cost camera can be used for resolution and modulation measurements.
© (1975) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ronald B. Ewart, Ronald B. Ewart, John H. Harshbarger, John H. Harshbarger, } "Measurement Of Flight Simulator Visual System Performance", Proc. SPIE 0059, Simulators and Simulation II: Design, Applications and Techniques, (1 September 1975); doi: 10.1117/12.954367; https://doi.org/10.1117/12.954367


Video system characterization
Proceedings of SPIE (September 13 1998)
Visual Problems Of Office Video Display Terminals
Proceedings of SPIE (August 15 1983)
Future Objectives Of Army Visual Simulation
Proceedings of SPIE (August 31 1975)
Visual Simulation The Old Way
Proceedings of SPIE (May 04 1986)

Back to Top