11 October 2005 TESLA cavity driving with FPGA controller
Author Affiliations +
Abstract
The digital control of the TESLA (TeV-Energy Superconducting Linear Accelerator) resonator is presented. The laboratory setup of the CHECHIA cavity in DESY-Hamburg has been driven by the FPGA (Field Programmable Gate Array) technology system. This experiment focused attention to the general recognition of the cavity features and projected control methods. The electrical model of the resonator is taken as a consideration origin. The calibration of the signal channel is considered as a key preparation for an efficient cavity driving. The identification of the resonator parameters is confirmed as a proper approach for the required performance: driving on resonance during filling and field stabilization during flattop time with reasonable power consumption. The feed-forward and feedback modes were applied successfully for the CHECHIA cavity driving. Representative results of experiments are presented for different levels of the cavity field gradient.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tomasz Czarski, Krzysztof Pozniak, Ryszard Romaniuk, Stefan Simrock, "TESLA cavity driving with FPGA controller", Proc. SPIE 5948, Photonics Applications in Industry and Research IV, 59480E (11 October 2005); doi: 10.1117/12.620165; https://doi.org/10.1117/12.620165
PROCEEDINGS
11 PAGES


SHARE
RELATED CONTENT

The RF control system for the DESY X-FEL
Proceedings of SPIE (July 22 2004)
Data simulator for the HERMES instrument
Proceedings of SPIE (July 20 2010)
Status of LLRF system development for European XFEL
Proceedings of SPIE (October 12 2006)
SIMCON ver.2.1: Configuration and Control Procedures
Proceedings of SPIE (October 06 2005)
Control system modeling for superconducting accelerator
Proceedings of SPIE (October 12 2006)

Back to Top