Translator Disclaimer
9 December 2005 Measurement of drill grinding parameters using laser sensor
Author Affiliations +
Proceedings Volume 6024, ICO20: Optical Devices and Instruments; 602418 (2005) https://doi.org/10.1117/12.666852
Event: ICO20:Optical Devices and Instruments, 2005, Changchun, China
Abstract
To measure the grinding parameters and geometry parameters accurately for a drill point is essential to its design and reconditioning. In recent years, a number of non-contact coordinate measuring apparatuses, using CCD camera or laser sensors, are developed. But, a lot work is to be done for further improvement. This paper reports another kind of laser coordinate meter. As an example of its application, the method for geometry inspection of the drill flank surface is detailed. Measured data from laser scanning on the flank surface around some points with several 2-dimensional curves are analyzed with mathematical procedure. If one of these curves turns to be a straight line, it must be the generatrix of the grinding cone. Thus, the grinding parameters are determined by a set of three generatrices. Then, the measurement method and data processing procedure are proposed. Its validity is assessed by measuring a sample with given parameters. The point geometry measured agrees well with the known values. In comparison with other methods in the published literature, it is simpler in computation and more accurate in results.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Peng Yanping, Hiroyuki Kumehara, Zhang Wei, and Takashi Nomura "Measurement of drill grinding parameters using laser sensor", Proc. SPIE 6024, ICO20: Optical Devices and Instruments, 602418 (9 December 2005); https://doi.org/10.1117/12.666852
PROCEEDINGS
7 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT


Back to Top