1 February 2006 Tolerance analysis of lenses with high zoom ratio
Author Affiliations +
Proceedings Volume 6034, ICO20: Optical Design and Fabrication; 60341P (2006) https://doi.org/10.1117/12.668163
Event: ICO20:Optical Devices and Instruments, 2005, Changchun, China
Abstract
Axial and lateral compensators are used for zoom systems tolerancing to improve the manufacturability of high zoom ratio lenses. An investigation into the tolerance distribution for various zoom ratios, and compensation conditions and corresponding performance is presented. A flexible method is applied to a rear focusing four-groups 10X zoom to demonstrate the effectiveness of different compensators.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Chir-Weei Chang, Gung-Hsuan Ho, Chy-Lin Wang, Wei-Chung Chao, John D. Griffith, "Tolerance analysis of lenses with high zoom ratio", Proc. SPIE 6034, ICO20: Optical Design and Fabrication, 60341P (1 February 2006); doi: 10.1117/12.668163; https://doi.org/10.1117/12.668163
PROCEEDINGS
7 PAGES


SHARE
RELATED CONTENT

Strategies for active alignment of lenses
Proceedings of SPIE (October 11 2015)
Tolerancing molded plastic optics
Proceedings of SPIE (September 12 2011)
Sensitivity control to surface irregularity
Proceedings of SPIE (July 18 2006)
Low-cost high-volume lens using diffractive technology
Proceedings of SPIE (November 01 1997)
The cost of tolerancing
Proceedings of SPIE (August 28 2009)

Back to Top