2 May 2006 Indoor localization and beacon calibration using ultrasonic and radio frequency
Author Affiliations +
Proceedings Volume 6042, ICMIT 2005: Control Systems and Robotics; 60423L (2006) https://doi.org/10.1117/12.664768
Event: ICMIT 2005: Merchatronics, MEMS, and Smart Materials, 2005, Chongqing, China
Abstract
Using the ultrasonic and the radio frequency, a method for the robot localization and calibration was presented. The distance between the receiver and a beacon can be computed by using the difference between times of flight. The presented method uses the gradient of the maximum amplitude of the ultrasonic in order to measure the time of flight precisely. The measured three distances between the receiver and the beacon were used to compute the robot position by the direct inverse method and the iterated least square approximation method. This paper defines the calibration as the problem to find the location of 3 beacons and 3 robots, and presents 3 methods for it and found the 2B2R method as the best among them.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jeong-Yong Yoon, Jeong-Yong Yoon, Kyoo-Sick Jung, Kyoo-Sick Jung, Dong-Hun Shin, Dong-Hun Shin, } "Indoor localization and beacon calibration using ultrasonic and radio frequency", Proc. SPIE 6042, ICMIT 2005: Control Systems and Robotics, 60423L (2 May 2006); doi: 10.1117/12.664768; https://doi.org/10.1117/12.664768
PROCEEDINGS
6 PAGES


SHARE
Back to Top