3 March 2006 Recovery of GaN surface after reactive ion etching
Author Affiliations +
Abstract
Surface properties of GaN subjected to reactive ion etching and the impact on device performance have been investigated by surface potential, optical and electrical measurements. Different etching conditions were studied and essentially high power levels and low chamber pressures resulted in higher etch rates accompanying with the roughening of the surface morphology. Surface potential for the as-grown c-plane GaN was found to be in the range of 0.5~0.7 V using Scanning Kevin Probe Microscopy. However, after reactive ion etching at a power level of 300 W, it decreased to 0.1~0.2 V. A nearly linear reduction was observed on c-plane GaN with increasing power. The nonpolar a-plane GaN samples also showed large surface band bending before and after etching. Additionally, the intensity of the near band-edge photoluminescence decreased and the free carrier density increased after etching. These results suggest that the changes in the surface potential may originate from the formation of possible nitrogen vacancies and other surface oriented defects and adsorbates. To recover the etched surface, N2 plasma, rapid thermal annealing, and etching in wet KOH were performed. For each of these methods, the surface potential was found to increase by 0.1~0.3 V, also the reverse leakage current in Schottky diodes fabricated on treated samples was reduced considerably compared with as-etched samples, which implies a partial-to-complete recovery from the plasma-induced damage.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Qian Fan, Qian Fan, S. Chevtchenko, S. Chevtchenko, Xianfeng Ni, Xianfeng Ni, Sang-Jun Cho, Sang-Jun Cho, Hadis Morko, Hadis Morko, } "Recovery of GaN surface after reactive ion etching", Proc. SPIE 6121, Gallium Nitride Materials and Devices, 61210Q (3 March 2006); doi: 10.1117/12.646856; https://doi.org/10.1117/12.646856
PROCEEDINGS
15 PAGES


SHARE
RELATED CONTENT

Radiation and process-induced damage in Ga2O3
Proceedings of SPIE (February 22 2018)
High pressure annealing of Europium implanted GaN
Proceedings of SPIE (February 27 2012)
Reactive Ion Etching of MBE GaAs A Raman Scattering...
Proceedings of SPIE (August 08 1988)
A comparison of wet and dry etching to fabricate a...
Proceedings of SPIE (December 29 2008)

Back to Top