30 March 2006 Solid polymer electrolyte membrane flow sensor for tracheal tube
Author Affiliations +
Abstract
Solid polymer electrolyte membrane (SPM) acts not only as an actuator but as a small, voltage generating, and fast response sensor. Sensing characteristics of SPM as applied to a flow sensor for a ventilator was studied. SPM was prepared by chemically plating with gold on the surface of Nafion membrane. A new technique using Nafion R-1100 resin was applied to fabricate SPM with an arbitrary thickness between 200-1000 μm. Flow sensing unit and signal amplifier was constructed to measure the induced voltage by bending SPM with air-flow from the ventilator. Induced voltage by SPM ranged 1-100 μV over a ventilator air-flow range of 20-100 L/min. SPM sensor showed linear increase of induced voltage by the increase of flow. This relationship was tested over a range of SPM thickness, length and width. The result was compared with an electro-mechanical coupling model of SPM transducer: data showed consistent result on the relation between the induced voltage and membrane length and thickness while a discrepancy was observed in the relation of membrane width and induced voltage. The result, however, was consistent with the assumption of capacitive component model.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tadashi Ihara, Tadashi Ihara, Yoshito Ikada, Yoshito Ikada, Taro Nakamura, Taro Nakamura, Toshiharu Mukai, Toshiharu Mukai, Kinji Asaka, Kinji Asaka, } "Solid polymer electrolyte membrane flow sensor for tracheal tube", Proc. SPIE 6167, Smart Structures and Materials 2006: Smart Sensor Monitoring Systems and Applications, 61670U (30 March 2006); doi: 10.1117/12.658928; https://doi.org/10.1117/12.658928
PROCEEDINGS
8 PAGES


SHARE
Back to Top