5 April 2006 Structural health monitoring using sparse distributed networks of guided wave sensors
Author Affiliations +
Abstract
The motivation for using guided acoustic waves as the sensing mechanism for large area structural health monitoring (SHM) is explained and the logic for using baseline signal subtraction as the fundamental signal processing tool is presented. In the first part of this paper, a simple experimental example is presented to illustrate how a guided wave SHM using baseline subtraction could be used to detect and locate simulated damage in a 1 m by 1.5 m by 3 mm thick aluminum plate. The experiment shows for an SHM system to be useful it must have a coherent noise floor around 40 dB lower in amplitude that the amplitude of a signal reflected from the edge of the structure. The experiment demonstrates that the sensitivity is severely limited by the stability of the baseline subtraction procedure which deteriorates rapidly over time. In the second part of the paper, the factors affecting the stability of the reference signal subtraction approach are investigated. Experimental and modeling studies on a simple test structure are presented that show that a change in temperature of a few degrees leads to coherent artifacts after baseline subtraction that are of a similar magnitude to the signals arising from defects. A possible strategy for overcoming this barrier to reliable baseline signal subtraction is then considered and shown to provide an improvement in sensitivity of around 10 dB.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Paul D. Wilcox, George Konstantinidis, Bruce W. Drinkwater, "Structural health monitoring using sparse distributed networks of guided wave sensors", Proc. SPIE 6173, Smart Structures and Materials 2006: Smart Structures and Integrated Systems, 61731L (5 April 2006); doi: 10.1117/12.658504; https://doi.org/10.1117/12.658504
PROCEEDINGS
12 PAGES


SHARE
Back to Top