Translator Disclaimer
Paper
21 April 2006 Tunable mechanical resonator with aluminium nitride piezoelectric actuation
Author Affiliations +
Abstract
The electromechanical response of piezoelectrically-actuated AlN micromachined bridge resonators has been characterized using laser interferometry and electrical admittance measurements. We compare the response of microbridges with different dimensions and buckling (induced by the initial residual stress of the layers). The resonance frequencies are in good agreement with numerical simulations of the electromechanical behavior of the structures. We show that it is possible to perform a rough tuning of the resonance frequencies by allowing a determined amount of built-in stress in the microbridge during its fabrication. Once the resonator is made, a DC bias added to the AC excitation signal allows to fine-tune the frequency. Our microbridges yield a tuning factor of around 88 Hz/V for a 500 μm-long microbridge.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
J. Olivares, J. Malo, S. González, E. Iborra, I. Izpura, M. Clement, A. Sanz-Hervás, J. L. Sánchez-Rojas, and P. Sanz "Tunable mechanical resonator with aluminium nitride piezoelectric actuation", Proc. SPIE 6186, MEMS, MOEMS, and Micromachining II, 61860K (21 April 2006); https://doi.org/10.1117/12.664444
PROCEEDINGS
12 PAGES


SHARE
Advertisement
Advertisement
Back to Top