29 January 2007 Observation and research of chip formation and efflux by high speed hard cutting
Author Affiliations +
Proceedings Volume 6279, 27th International Congress on High-Speed Photography and Photonics; 62794M (2007); doi: 10.1117/12.725427
Event: 27th International congress on High-Speed Photography and Photonics, 2006, Xi'an, China
Abstract
This paper observed the chip forming and effusing process when high speed hard turning hardened steel using PCBN tools under two-dimensional longitudinal turning and transverse turning by high-speed photography, and obtained the chip formation and efflux states with different cutting edge preparation and parameters. The experiment results showed that the sharp-edged tool was useful for chip forming, but strength of its edge is low and the tool life is short, and that the tool has longer life under the chamfered edge, but too small or too large cutting thickness goes against the chip forming and effusing.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Xianli Liu, Fugang Yan, Yu Wang, Yiwen Wang, Hongmin Pen, Tao Chen, "Observation and research of chip formation and efflux by high speed hard cutting", Proc. SPIE 6279, 27th International Congress on High-Speed Photography and Photonics, 62794M (29 January 2007); doi: 10.1117/12.725427; https://doi.org/10.1117/12.725427
PROCEEDINGS
5 PAGES


SHARE
KEYWORDS
Cameras

High speed photography

Resistance

Photography

Computer simulations

Energy efficiency

High speed cameras

Back to Top