Paper
13 October 2006 Surface roughness parameters measurements by digital holographic microscopy (DHM)
Frédéric Montfort, Yves Emery, Eduardo Solanas, Etienne Cuche, Nicolas Aspert, Pierre Marquet, Claude Joris, Jonas Kühn, Christian Depeursing
Author Affiliations +
Proceedings Volume 6280, Third International Symposium on Precision Mechanical Measurements; 62800V (2006) https://doi.org/10.1117/12.716113
Event: Third International Symposium on Precision Mechanical Measurements, 2006, Urumqi, China
Abstract
Digital Holographic Microscopes (DHM) allows the capture of all the information necessary to provide 3D phase measurements with a nanometer vertical resolution in a single image acquisition. DHM images provide measurements of the surface topography which can be used for surface analysis, roughness measurements for example. In this paper we present roughness measurements on micro-balls of different sizes for which numerical procedures are applied for form factor and waviness removal. DHM thus permits quantitative measurements of the roughness on a 2 dimensional area allowing enlarged information compared to common profilometers. Mean roughness of 5 to 30 nm are measured and compared to values obtained by a profilometer.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Frédéric Montfort, Yves Emery, Eduardo Solanas, Etienne Cuche, Nicolas Aspert, Pierre Marquet, Claude Joris, Jonas Kühn, and Christian Depeursing "Surface roughness parameters measurements by digital holographic microscopy (DHM)", Proc. SPIE 6280, Third International Symposium on Precision Mechanical Measurements, 62800V (13 October 2006); https://doi.org/10.1117/12.716113
Lens.org Logo
CITATIONS
Cited by 8 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Profilometers

Digital holography

Holograms

Holography

Radium

3D metrology

Image acquisition

Back to Top