Translator Disclaimer
20 May 2006 Advanced process control of mask dry-etching using RF sensor
Author Affiliations +
Proceedings Volume 6283, Photomask and Next-Generation Lithography Mask Technology XIII; 62830D (2006)
Event: Photomask and Next Generation Lithography Mask Technology XIII, 2006, Yokohama, Japan
Advanced process control (APC) of photomask dry-etching has been studied for strict mean control of both CD and phase angle of phase shift masks (PSMs). Equations to correlate process information with actual etching results have been developed for this purpose. It is showed that plasma reactance measured with RF sensor has noticeable correlation with Cr etching bias, which is affected by Cr load and condition of etching chamber. Simulation of etching bias based on plasma reactance shows the good agreement with the trend of actual etching results. Expectation of process capability index (Cpk) for mean-to-target (MTT) within 5.2nm is about 1.27, corresponding to CD yield more than 99.9%. In case of MoSi based PSMs, monitoring the sensor outputs is also useful to simulate the etching rate of phase shifter. One simple relationship can be also derived as the case of Cr etching bias. Expected phase error is within 1.5degree in almost cases. In actual photomask fabrication, maintenance of the equation for APC is a critical issue to guarantee the high process yield for a long period. It is showed that trend of the plasma reactance gives the meaningful information effective in automatic maintenance of the equations. As a conclusion, it is proved that our APC method is one of the answers to give the highest MTT yield for both CD and phase angle.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Hitoshi Handa, Satoshi Yamauchi, Koji Hosono, Hiroshi Maruyama, Daisuke Nakamura, Toshifumi Yokoyama, and Akihiko Naito "Advanced process control of mask dry-etching using RF sensor", Proc. SPIE 6283, Photomask and Next-Generation Lithography Mask Technology XIII, 62830D (20 May 2006);


CD bias control with in situ plasma treatment in EPSM...
Proceedings of SPIE (October 29 2007)
Dry etching of Cr layer and its loading effect
Proceedings of SPIE (September 04 2001)
Improvement of chrome CDU by optimizing focus ring design
Proceedings of SPIE (August 27 2003)
Investigation of Cr etch kinetics
Proceedings of SPIE (December 16 2003)

Back to Top