Paper
30 August 2006 Effects of material improvement on CZT detectors
Author Affiliations +
Abstract
CZT material quality improvement has been achieved by optimizing the crystal growth process. N-type conductivity has been measured on as-grown, undoped Cd0.9Zn0.1Te. Cd 0.85 Zn 0.15Te crystals have been grown for producing high resistivity CZT radiation detectors. The best FWHM of 57Co 122KeV spectrum was measured to be 3.7% and (µτ)e was 3x10-3 cm2V-1. The microscopic gamma ray response using a beam size of 10µm has been used to map the entire 4 mm x 4 mm detector. Several black spots indicating no signal responses were observed while all other areas showed an average of 65-70% collection efficiency. The black spots suggest that at those locations, the Te precipitates are larger than 10μm. Detailed microscopic infrared transmission measurement on the sample found that most Te precipitates have sizes of 4-6μm. Theoretical analysis of the results suggests that singly and doubly ionized TeCdVCd2 might be the shallow and deep donors previously assigned to TeCd by us.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Muren Chu, S. Terterian, D. Ting, G. A. Carini, G. S. Camarda, A. E. Bolotnikov, R. B. James, D. Xu, and Z. He "Effects of material improvement on CZT detectors", Proc. SPIE 6319, Hard X-Ray and Gamma-Ray Detector Physics and Penetrating Radiation Systems VIII, 631905 (30 August 2006); https://doi.org/10.1117/12.683980
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Tellurium

Cadmium

Sensors

Zinc

Crystals

Gamma radiation

Mercury cadmium telluride

RELATED CONTENT


Back to Top