27 April 2007 Zero-power shock sensors using bistable compliant mechanisms
Author Affiliations +
This paper demonstrates the design, fabrication, and analysis of a small plastic latching accelerometer, or shock sensor, that is bi-stable and functions without the use of electricity. The sensor has two stable mechanical states. When force above a certain threshold limit is applied, the sensor changes states and remains in the changed state indicating the amount of force that has been applied to the sensor. The devices were laser-cut from ABS and Delrin plastics, and the surface area of the free-moving section was varied to produce sensors with a range of force sensitivities. The switching action of the devices was analyzed with the use of a centrifuge, which supplied the necessary force to switch the accelerometers from one mechanical state to another. The surface area of the sensors varied from 100 mm2 to 500 mm2 and the G-force sensitivity range varied between 10 and 800 g.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Brett J. Hansen, Brett J. Hansen, Christopher J. Carron, Christopher J. Carron, Aaron R. Hawkins, Aaron R. Hawkins, Stephen M. Schultz, Stephen M. Schultz, } "Zero-power shock sensors using bistable compliant mechanisms", Proc. SPIE 6525, Active and Passive Smart Structures and Integrated Systems 2007, 65251W (27 April 2007); doi: 10.1117/12.715230; https://doi.org/10.1117/12.715230


Hybrid approach to MEMS reliability assessment
Proceedings of SPIE (January 18 2007)
Reliability enhancement of Ohmic RF MEMS switches
Proceedings of SPIE (February 17 2011)
Switch power supply of fast axial flow CO2 laser for...
Proceedings of SPIE (January 03 2008)
Hybrid reconfigurable OADM using MEMS switch and FBG
Proceedings of SPIE (September 02 2002)
Status of the MEMS industry
Proceedings of SPIE (January 21 2005)
The reliability of RF MEMS failure modes, test procedures,...
Proceedings of SPIE (December 22 2003)

Back to Top