18 June 2007 Enhancements to FDTD modeling for optical metrology applications
Author Affiliations +
Proceedings Volume 6617, Modeling Aspects in Optical Metrology; 66170U (2007); doi: 10.1117/12.726188
Event: Optical Metrology, 2007, Munich, Germany
This paper presents Finite Difference Time Domain (FDTD) method based on discretised Maxwell curl equations and widely used in microwave circuit design - as a promising tool for new optical metrology purposes. We focus on periodic FDTD formulations for scattering problems. The interest in efficient full-wave modelling of periodic structures has arisen due to their increasing applications as slow wave transmission lines, photonic crystals, and metamaterials. Recently, new efforts have been made to incorporate the FDTD algorithms into the scatterometry overlay technology (SCOL) toolkit. In SCOL, multilayered grating targets on silicon wafers are illuminated with polarised light at a particular angle of incidence; reflected signal of the 0th diffraction order is processed to extract the information about misalignment between grating layers. Since the illumination spot size typically covers tens or even hundreds of grating periods, direct 3D FDTD modelling of such an electrically large problem needs long computing times. The periodic FDTD algorithm discussed herein, built upon Floquet theorem, allows reduction of the modelling problem to one or just a few periods. As a consequence, it substantially speeds up the simulation. The incident wave is modelled as a plane wave. The reflected wave is extracted via near-to-far (NTF) transformation as in antenna analysis. We cross-calibrate the FDTD algorithm against other numerical techniques better established in optical metrology, like Rigorous Coupled Wave Analysis (RCWA). For a benchmark of multilayered rectangular grating composition illuminated with light within the 500 to 700 nm spectrum, we show that the FDTD and RCWA results for the 0th diffraction order reflection coefficient are in excellent agreement. The FDTD approach is more flexible as it further allows quantitative characterisation of non-rectangular periodic structures, higher-order diffraction rays, and periodicity violation. This work was done in the framework of the SOCOT Consortium [18], sponsored by the European Commission under the IST 6th Framework Programme, Contract No. 016403.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Bartlomiej Salski, Malgorzata Celuch, Wojciech Gwarek, "Enhancements to FDTD modeling for optical metrology applications", Proc. SPIE 6617, Modeling Aspects in Optical Metrology, 66170U (18 June 2007); doi: 10.1117/12.726188; https://doi.org/10.1117/12.726188

Back to Top