22 September 2007 Application of Kramers-Kronig method for analysis Fe-based alloys
Author Affiliations +
Abstract
The approach described in the present paper was applied for analysis of Fe-based amorphous and crystallized alloys. All the analyzed specimens have Sw~1. Using classical approach to the Kramers-Kronig transform this value is insufficient for refraction index and therefore optical conductivity determination. The present paper considers new ways of Kramers-Kronig transform accuracy increase by use of high-order quadrature method and new approach to reflectivity extrapolation. Using the advanced described approach a set of amorphous and crystallized alloys of Fe80TM5B15 type was analyzed where TM is the 3d-transition metal. It is shown while adding a small amount of Ti, V or Cr the observed plasma frequency tends to be about 3 to 4 eV higher than in case Mn, Co or Ni impurity was added. The proposed method error of the optical constants determination estimate is not greater than 15% for refraction and absorption indexes and 25% for conductivity even in case experimental spectral range is relatively small. Plasma frequency of analyzed specimens was calculated. The methods of plasma frequency determination were compared. Determination of base points by direct method allows significant accuracy increase and adequate error estimation of this value.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Oliana Fedosenko, Eugene Loza, Leonid V. Poperenko, "Application of Kramers-Kronig method for analysis Fe-based alloys", Proc. SPIE 6641, Plasmonics: Metallic Nanostructures and Their Optical Properties V, 66411Y (22 September 2007); doi: 10.1117/12.732418; https://doi.org/10.1117/12.732418
PROCEEDINGS
9 PAGES


SHARE
Back to Top