9 January 2008 Mechanical quality factor of microcantilevers for mass sensing applications
Author Affiliations +
Abstract
Mechanical quality factor (Q-factor) is essential to detect-limitation of a resonant based mass sensor because it determines signal to noise ratio. This paper studies the effects of different energy dissipation mechanisms, including air damping, support loss and thermoelastic damping (TED), on Q-factor of a microcantilever under atmospheric pressure conditions. The contribution of each mechanism was analyzed at various cantilever geometry. And the precondition to Z.Hao's model, which describes the support loss effect by elastic wave theory, was discussed. It was found that in 5 μm-thick silicon cantilevers, air damping was the predominant reason to energy dissipation when cantilever length was larger than 140 μm. The support loss and TED became noteworthy at shorter cantilevers when cantilever length to thickness ratio (L/t) was less than 20. Q-factor of a microcantilever thus can be improved by increasing the cantilever thickness to suppress air damping, but not infinitely because the support loss became comparable to air damping when cantilever thickness was increased. Moreover, it was found that the Q-factor of a multi-layered microcantilever was degraded markedly with the increase of layer numbers.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jian Lu, Jian Lu, Tsuyoshi Ikehara, Tsuyoshi Ikehara, Yi Zhang, Yi Zhang, Takashi Mihara, Takashi Mihara, Ryutaro Maeda, Ryutaro Maeda, } "Mechanical quality factor of microcantilevers for mass sensing applications", Proc. SPIE 6800, Device and Process Technologies for Microelectronics, MEMS, Photonics, and Nanotechnology IV, 68001Y (9 January 2008); doi: 10.1117/12.759393; https://doi.org/10.1117/12.759393
PROCEEDINGS
8 PAGES


SHARE
RELATED CONTENT


Back to Top