11 January 2008 A new calibration approach of rotor axes for 3D measurement system
Author Affiliations +
Abstract
Rotating scan is a common 360-degrees measurement method in 3D measure system which based on line-structure light. In this system, the calibration for rotary axis of the rotary platform is an important section. It will be affecting the measurement results. In known methods, precision and expensive auxiliary instruments are required to ensure that the rotation axis is located in the plane of line-structure light. In this paper, a simple, flexible and real-time calibration method is proposed. Firstly, a plane calibration board with tessellated pattern is placed incline on the rotating stage. Secondly, recoded several pictures of the calibration board while the stage rotating several angles. Thirdly, the parameters of camera (include the intrinsic parameters and the extrinsic parameters, such as rotating matrixes and transform vectors between the local coordinates of these planes and the global coordinate of sensor) can be estimated from these pictures. Then, the global coordinates of these control points were calculated according to these parameters. Finally, the axis parameters of the working stage can be optimized with these control points because the global coordinates of same control point in different position are in circle. This method is proved by experiment, and the root-mean-square error is 0.04mm.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Qingyang Wu, Qingyang Wu, Jingzhen Li, Jingzhen Li, Xianyu Su, Xianyu Su, Bin Hui, Bin Hui, } "A new calibration approach of rotor axes for 3D measurement system", Proc. SPIE 6837, Information Optics and Photonics Technologies II, 68371B (11 January 2008); doi: 10.1117/12.757378; https://doi.org/10.1117/12.757378
PROCEEDINGS
9 PAGES


SHARE
RELATED CONTENT

New calibration approach for light stripe sensor
Proceedings of SPIE (November 26 2007)
Basic scanner for parallepipedic manufactured pieces
Proceedings of SPIE (February 16 2007)
3D cutting tool inspection system and its key technologies
Proceedings of SPIE (September 10 2009)

Back to Top